[linux] adaptec aic7xxx/aic79xx + zerro channel raid

[Marek Slebodnik]

cafte 

Mame ten isty radic, a 
radsej sme to rozbehali ako sw raid. No docital som sa o Zero channel
raid , kt je rozsirenim pre tieto radice . MA nie kto s tym nejake
skusenosti ?


> ahojte,
> 
> nemate niekto tu cest s adapterom adaptec aic7901? uz dlhsiu dobu sa mi 
> akosi nedari 'dohodnut' sa s nim. skusam pouzit modul z jadra, 
> kompilovat zo zdrojakov od vyrobcu, no stale bez pozadovaneho vysledku. 
> modul ma kopec moznych parametrov, mozno je problem tam, no neviem najst 
> spravnu kombinaciu.
> 
> system RH7.3
> kernel 2.4.18-3 (RH package), 2.4.20 (RH package), 2.4.31 (kernel.org src)
> 
> # lspci -s 05:03.0 -v
> 05:03.0 RAID bus controller: Adaptec: Unknown device 0250 (rev 02)
>         Subsystem: IBM: Unknown device 028c
>         Flags: bus master, stepping, 66Mhz, medium devsel, latency 64, 
> IRQ 22
>         Memory at f3fff000 (32-bit, non-prefetchable) [size=4K]
>         Memory at f4000000 (32-bit, prefetchable) [size=64M]
>         Expansion ROM at <unassigned> [disabled] [size=512K]
>         Capabilities: [c0] Power Management version 2
>         Capabilities: [d0] Message Signalled Interrupts: 64bit+ 
> Queue=0/1 Enable-
>         Capabilities: [e0] PCI-X non-bridge device.
> 
> 
> # insmod aic79xx
> Using /lib/modules/2.4.31/kernel/drivers/scsi/aic7xxx/aic79xx.o
> /lib/modules/2.4.31/kernel/drivers/scsi/aic7xxx/aic79xx.o: init_module: 
> No such device
> Hint: insmod errors can be caused by incorrect module parameters, 
> including invalid IO or IRQ parameters.
>       You may find more information in syslog or the output from dmesg
> 
> dakujem za kazde nakopnutie.
> 
> horol
> _______________________________________________
> http://lists.linux.sk/listinfo/linux
> Prehladavanie archivu: http://search.lists.linux.sk
> Meta FAQ: http://www.sklug.sk/lists/linux/metafaq.html